Vintage Dirt Bike Q & A • View topic - Turbo throttle on CR250M

View unanswered posts | View active topics

Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]

Turbo throttle on CR250M

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

mx317

Post subject: Turbo throttle on CR250M

Posted: Sat May 31, 2008 7:39 am

Joined: Thu Jan 03, 2008 7:27 am
Posts: 47

Anyone used a Motion Pro Turbo throttle (Gunnar Gasser replica) on a 74 CR250M with an aftermarket Mikuni 36mm? I bought the suggested cable (01-0249) in the Parts Unlimited catalog and the inner cable is too short. I've tried taking the nut off the adjuster on both ends and still no luck. The cable hooks into the bottom of the slide with a plate to keep the needle and cable in place. Outer housing is 42.2" and cable is 51". I sent an email to Motion Pro, but have not heard back yet. Any suggestions?

Top

redrocket190

Post subject: Re: Turbo throttle on CR250M

Posted: Sat May 31, 2008 8:57 am

Joined: Fri Feb 27, 2004 10:20 pm
Posts: 906
Location: San Clemente, CA

Go to Terry Cable (http://www.terrycable.com) and tell them the type of throttle, bike, and carb and they'll make one to fit....I use a Motion Pro "Gunnar Gasser" and Mikuni VM36 on a 1979 CR250R.

_________________
Michael Stiles
1979 Honda CR250R Elsinore | 2006 Husqvarna SM510R | 2007 Service Honda CR500R-AF

Top

Page 1 of 1

[ 2 posts ]

Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 101 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum