Vintage Dirt Bike Q & A
http://vintagedirtbikeforums.alp-sys.com/

Elsinore 250 piston CH ?
http://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=4750
Page 1 of 1

Author:  friday [ Tue Mar 21, 2017 1:57 pm ]
Post subject:  Elsinore 250 piston CH ?

Hi all
Ive researched Wossner piston 8152DA standard bore 70mm , info says compression height is 32mm

- is that CH measured from the wrist pin centre to the crown or is it from above the pin hole to crown ???

- also is the 1975 - 80 Elsinore piston CH the same ??? it would seem a possible variable thru the yrs

I dont have a piston in hand , cheers

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/