Vintage Dirt Bike Q & A
http://vintagedirtbikeforums.alp-sys.com/

MT250 carb removal
http://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=6137
Page 1 of 1

Author:  starrblade [ Wed Jun 27, 2018 8:56 pm ]
Post subject:  MT250 carb removal

What is the easiest way to remove the carb from a MT250? Silly question I know, but there's got to be a way that's better than yanking it out forcibly. Thanks :D

Author:  rayivers [ Thu Jun 28, 2018 7:32 am ]
Post subject:  Re: MT250 carb removal

You can try heating the manifold and air boot with a heat gun on low, then pushing the carb back against the boot while rotating it out of the manifold, I usually just unbolt the manifold on my MR, but that's kind of a pain with the MT oil injection.

Author:  mafd2 [ Wed Aug 19, 2020 6:21 pm ]
Post subject:  Re: MT250 carb removal

starrblade wrote:
What is the easiest way to remove the carb from a MT250? Silly question I know, but there's got to be a way that's better than yanking it out forcibly. Thanks :D

Remove the carb with the intake boot then carb from boot.

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/