Vintage Dirt Bike Q & A
http://vintagedirtbikeforums.alp-sys.com/

How to lace my wheel with new spokes
http://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=33&t=3731
Page 1 of 1

Author:  munk1958 [ Sun Jun 10, 2012 8:44 pm ]
Post subject:  How to lace my wheel with new spokes

I have a new set of spokes and a new wheel which I am trying to lace up. I downloaded the instructions from the service manual and have followed it closely. I have the spokes laced on the large brake drum side, but am having a rough time trying to get the spokes in on the other smaller side. I can't seem to get enough give to shift the wheel enough to get the spoke to engage the nipple. It is a little to short. There must be some tricks to putting these things together. It's a 75 CR250. Any advise? Thanks, Mark :(

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/