Vintage Dirt Bike Q & A
http://vintagedirtbikeforums.alp-sys.com/

Bultaco 250 crankshaft, clutch interchangeability?
http://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=35&t=2702
Page 1 of 1

Author:  claytonia [ Wed Jun 02, 2010 2:14 pm ]
Post subject:  Bultaco 250 crankshaft, clutch interchangeability?

I have a 250 Pursang Mk.4 (mod. 68) that I am hoping to restore. The block is still together, but I'm planning on doing a rebuild on it (bearings, seals, gaskets, etc.). The rod big end bearing is definitely shot, but I'm not sure how feasible/expensive it is to replace it - do I take it to a machine shop or bike shop to have it separated and pressed back together, then aligned? There are several cranks w/rods in decent shape on eBay, but I am not sure which various years/models are interchangeable. The same for the clutch, as the sprocket teeth are shot and i need to replace it.

Thanks for any help or advice!

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/