Vintage Dirt Bike Q & A

Anything and everything about Vintage Dirt Bikes! After you Register, email nathan@alp-sys.com and let me know so I can activate you.
It is currently Fri Dec 15, 2017 7:37 pm

All times are UTC - 7 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed Jan 01, 2014 4:50 pm 
Offline

Joined: Sat Dec 21, 2013 6:13 am
Posts: 2
I am building a trails bike out of left over parts from a B44 Victor Special project. I want more travel in the front end and as I don't have the stock forks I picked up a front end off a 1982 Honda XL500. I am going to machine adapters so I will be using the Honda stock 47mm OD bearings. What I need is the total height of the head stock from top bearing race to bottom bearing race and the OD of the head stock at the bearing races so I can figure the length of the adapters. Also some pictures of the fork stop would be helpful. I am located about 30 miles west of Chicago where the concrete turns to corn. If you want contact me off list. Any help would be appreciated.

Thanks

Trig


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 7 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group