Vintage Dirt Bike Q & A

Anything and everything about Vintage Dirt Bikes! After you Register, email nathan@alp-sys.com and let me know so I can activate you.
It is currently Thu Jun 19, 2025 5:36 pm

View unanswered posts | View active topics


Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
jedi61
PostPosted: Wed Jun 08, 2011 12:26 am 
Offline

Joined: Sat Jun 04, 2011 11:55 pm
Posts: 1
On the water pump side of the crankshaft there is a metal collar that goes on the crankshaft and turns in the crank seal.
Is their an o ring that goes behind this collar to prevent leakage between the collar and the crankshaft? The honda service manual does not show any o ring behind the collar and the honda dealer could not help.
The Clymer repair manual says to replace the o ring with every rebuild, if this is the case; where can I get this o ring.
Thank you for your help.
Top
 Profile  
 
davep
PostPosted: Wed Jun 08, 2011 8:37 am 
Offline

Joined: Sun Jan 17, 2010 12:04 pm
Posts: 26
i have a 82 and a 81 bilt both engines there is no o ring there is a tapered end that seals
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 23 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group