Vintage Dirt Bike Q & A

Ive been searching online for the inlet manifold for the 1973 or 1974 CR250 to complete my top end conversion for my MT250 as I only have one for my two units and the rubber is ripped.

Whilst i found the original part on the online fiche's for the CR250M (part number 16220381000) I cant actually locate any for sale at this time. So... I thought I would ask those that know about such things as the whole early CR's are a mystery to me, although I am getting better by the day, haha

- Does anyone know or have a line on an alternative unit that will do the job for me, or can I somehow re use the MT250 parts after boring them out or making some changes?

- Right now I dont have any carbs for these top ends as yet so if there was another similar manifold (MR/MT/CR/FL etc etc) that fitted but had a larger carb entry hole then I could source a carb to fit the boot later and go that route of course.

Thanks for your help guys, its always appreciated.

_________________
MT250 with CR250 top end & Bassani pipe... almost fully restored.

See more of my motorbike builds at my Honda MT250 and Yamaha RD and RZ website, 2Smoked.com

If you like watches, check out my websites: DeskDivers.com & PloProf.com