Vintage Dirt Bike Q & A

wWow I'm starting to get mad this site sure as hell is not phone friendly this is the third time I've tried to make this post if it doesn't go this time oh well I've go I've got 50,000 sho shop hours wor working on everything from semis and heavy equipment could drag cars and motocross bikes that seal is too small ID the crankshaft seal should snugly fit the ID should snugly fit around the end of the crank where rest set TRX 250 or motor TRX 250 R motor of mine less than a week ago and the crank shaft seals are supposed to be 6 millimeter inset which is roughly about a quarter inch eyeball it and adjust it where you need it so your off the old seal wear line better off to clean you're better off to clean it up and be on nu metal. Please forgive my phone for being retarded I'm doing talk to text and I'm not freaking change it again I'm just trying to be helpful the seals that you need are in the closest city to you there either at a hydraulic repair shop a motor rewind place a heavy equipment dealer a semi dealership or Napa depending on what competent people you can find in those places that are willing to help you all you have to do is have your ID your od andyour thickness and somebody should be able to match you up provided you give them the application meaning its going to be a crankshaft sealh