Vintage Dirt Bike Q & A

Anything and everything about Vintage Dirt Bikes! After you Register, email nathan@alp-sys.com and let me know so I can activate you.
It is currently Sat Jul 05, 2025 9:03 pm

View unanswered posts | View active topics


Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
purf_man
PostPosted: Tue May 09, 2006 8:01 pm 
Offline

Joined: Mon Apr 24, 2006 6:47 pm
Posts: 4
Location: Ann, IL
well I just picked up a kinda running mt250 (flooding carb and barely there coil wire....)

so I am ordering up a new coil to toss on it and tore it down to a bare frame and have refinished it all and started getting it back together but was wondering if I can swap in some tapered bearings on the headstock?

also is there no bearings or bushings on the swingarm? all I see is a knurled steel hole on the arm and a grrease fitting?

_________________
1975 MT250
1975 CB550
1993 RM80 (for sale)
Top
 Profile  
 
Elsinorestuff
 Post subject:
PostPosted: Wed May 10, 2006 9:45 pm 
Offline

Joined: Fri Apr 15, 2005 9:49 pm
Posts: 86
I believe jastco.com has the brass replacement swingarm bushing you need. They are the same as a 74 CR250. In the Vintage Views there are guys selling the tapered bearing replacements for CR250s should be the same as the MT. Check AHRMA.org maybe they are listed online.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 41 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group