Vintage Dirt Bike Q & A

Anything and everything about Vintage Dirt Bikes! After you Register, email nathan@alp-sys.com and let me know so I can activate you.
It is currently Sat Dec 21, 2024 12:25 pm

View unanswered posts | View active topics


Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
Terry Gates
 Post subject: 1980 CR250R speed??
PostPosted: Mon Apr 07, 2003 4:25 pm 
Anyone know tips for getting the '80 CR250R to rev better and run like '78-'79s?? Reed changes or pipes to use???
Top
  
 
Les Chislett
 Post subject: Re: 1980 CR250R speed??
PostPosted: Mon Apr 07, 2003 4:27 pm 
Try dropping your slide needle one notch. That is. Take the clip off the needle and clip it in one notch higher thus dropping the needle. Rev the engine listen if it sounds crisper and snappier... check for lean running after you do a chop test at full throttle when riding.
Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 29 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group