| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| just got an mt250...looking for stuff https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=1032 |
Page 1 of 1 |
| Author: | purf_man [ Tue May 09, 2006 8:01 pm ] |
| Post subject: | just got an mt250...looking for stuff |
well I just picked up a kinda running mt250 (flooding carb and barely there coil wire....) so I am ordering up a new coil to toss on it and tore it down to a bare frame and have refinished it all and started getting it back together but was wondering if I can swap in some tapered bearings on the headstock? also is there no bearings or bushings on the swingarm? all I see is a knurled steel hole on the arm and a grrease fitting? |
|
| Author: | Elsinorestuff [ Wed May 10, 2006 9:45 pm ] |
| Post subject: | |
I believe jastco.com has the brass replacement swingarm bushing you need. They are the same as a 74 CR250. In the Vintage Views there are guys selling the tapered bearing replacements for CR250s should be the same as the MT. Check AHRMA.org maybe they are listed online. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|