| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| After market chain roller https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=1083 |
Page 1 of 1 |
| Author: | Michigan_Archer [ Sun Jul 02, 2006 2:43 pm ] |
| Post subject: | After market chain roller |
Hi, does anyone know of a good aftermarket chain roller for my 79 CR250R? Thanks, Joe. |
|
| Author: | redrocket190 [ Wed Jul 05, 2006 11:50 am ] |
| Post subject: | |
This is covered in other threads. Most of the modern after-market rollers use a bolt that is smaller than the hole in the mounting bracket on the frame. Issue #2 is that if you are running an after-market swing arm it will pinch the chain against a stock-sized roller. I am currently running a sleeve of nylon washers over the correct-sized bolt. Sam Alexander says that http://www.jastco.com is coming up with solution. |
|
| Author: | magoo [ Wed Jul 05, 2006 3:08 pm ] |
| Post subject: | Chain rollers |
I have chain rollers and chain sliders for every model Honda CR from 1973 through to 1984. Email mailto:red_devil_racing@hotmail.com for prices. |
|
| Author: | Michigan_Archer [ Sat Jul 08, 2006 9:58 am ] |
| Post subject: | |
Hi everyone, I am going to try and fabricate a chain roller using some after market parts out of a catalog. The problem is that I don't know what the outer diameter of the roller is. Does anyone know this dimension? Thanks, Joe |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|