I can get them out, but its not an approved way of doing it. Professional mechanics would shake there heads in shame at me if i posted it on here...lol. It basically involves a hammer and a long screwdriver or a long ratchet extension.
| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| bearings https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=125 |
Page 1 of 1 |
| Author: | robbie [ Wed Feb 11, 2004 5:19 pm ] |
| Post subject: | bearings |
how do you get bearings out of rear wheel on 1979 cr250 |
|
| Author: | MXRose3 [ Fri Feb 13, 2004 8:59 am ] |
| Post subject: | rear wheel bearings |
I can get them out, but its not an approved way of doing it. Professional mechanics would shake there heads in shame at me if i posted it on here...lol. It basically involves a hammer and a long screwdriver or a long ratchet extension.
|
|
| Author: | Rick [ Fri Feb 13, 2004 11:47 pm ] |
| Post subject: | |
That works fine, esp if you are replacing the bearings. Also, a hand held propane torch sometimes makes them drop out. Just a little heat, till you can't touch the metal with bare hands will do. Ambient above 60F. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|