Vintage Dirt Bike Q & A

Anything and everything about Vintage Dirt Bikes! After you Register, email nathan@alp-sys.com and let me know so I can activate you.
It is currently Mon Nov 28, 2022 4:16 pm

All times are UTC - 7 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Tue Mar 02, 2021 12:40 pm 
Offline

Joined: Thu Jan 03, 2008 7:27 am
Posts: 47
I bought a set of Allen screws for the racer I’m building. There is one case bolt that is 70mm long that won’t work anywhere. The stock screw is 70mm but is threaded for most of the screw. Which hole does it go in? The manual doesn’t say and when you drop them in the case they are sticking up the same amount. It looks like one hole goes through to the clutch side and looks right but not 100% sure. 1974 CR250M.


Top
 Profile  
 
PostPosted: Tue Mar 02, 2021 4:30 pm 
Offline

Joined: Sat Jun 03, 2017 1:39 pm
Posts: 35
Location: London , England
From memory the only 70mm screw connects the two crank halves . Probably the lower hole on the LH case (not behind the stator)


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 7 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group