Vintage Dirt Bike Q & A

Anything and everything about Vintage Dirt Bikes! After you Register, email nathan@alp-sys.com and let me know so I can activate you.
It is currently Mon Jul 07, 2025 5:23 pm

View unanswered posts | View active topics


Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
Gus Pingforit
PostPosted: Sun Nov 11, 2007 11:05 am 
Offline

Joined: Sun Nov 11, 2007 10:46 am
Posts: 5
Location: United Kingdom
Hi, Can anyone help. I have just put my 250CR engine back together with new main seals, and seem to have a pin left over which I can not see (diagrams) anywhere in the owners manual? :lol:
The Pin is the thickness of a pencil and about an Inch long with a groove that runs round the pin about 3/4 of the way down, and one end seems to be shamferred.
Hope the picture is attached OK.
Any help greatly recieved.
Thanks, Paul. :)


Attachments:
Honda Pin.JPG
Honda Pin.JPG [ 4.78 KiB | Viewed 3505 times ]
Top
 Profile  
 
ktm450exc
PostPosted: Sun Nov 11, 2007 11:47 am 
Offline

Joined: Fri May 05, 2006 10:26 am
Posts: 98
Location: no where
Looks like it might be a piece broken off the clutch actuator shaft. Check yours, Ive seen the ends break off
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 9 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group