Vintage Dirt Bike Q & A

I am have trouble finding the 2 roller bearings in the clutch basket for a 76 cr250. I was told by the dealer honda no longer has them. Does anyone know of another year that will work. Thanks Ron

The bearings in these bikes are almost always a standard issue bearing manufactured by others. If you have your old bearings, you can likely take them to a bearing distributor (Allied Bearings or someone like that) and they can measure them and either sell you some or order them for you. Both bearings are the same, if I remember right. I haven't replaced those particular bearings, however, so I don't have the number you'll need. I'll bet someone else on this forum has been through this and can give you the size or bearing number you'll need. Good luck.

Try here-
http://www.mrcycles.com/fiche_select.asp
I don't know if they have them,but they list the dimensions,25x29x17,with the new and old part#'s.I think all Honda part books list either size or number on all bearings and seals since as mitchie says they are a standard size.