| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| 79 cr 250 jug (cyl) https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=1837 |
Page 1 of 1 |
| Author: | digitalbrad [ Sun Apr 20, 2008 9:57 pm ] |
| Post subject: | 79 cr 250 jug (cyl) |
since i'm sure there are some of you that have seen a brand new or newly rebuilt jug for your 79 cr 250, and i know they are chrome bored or nikasil or something like that IE. not a normal steal boreable jug so my question is, Do the new jugs look just like a normal one in the way of it being cross hatched and such. I was told mine has a fresh top end and it was done in a shop and was just unsure of what it would be looking like with the special cyl. |
|
| Author: | redrocket190 [ Sat May 17, 2008 8:39 pm ] |
| Post subject: | Re: 79 cr 250 jug (cyl) |
It should be obvious whether it is a cylinder with the original chrome, or whether a sleeve has been inserted. In the latter case you will see the join at the edge of the ports. If you are in any doubt take the cylinder to a shop and have it measured and matched to a piston and the cylinder honed as necessary. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|