Vintage Dirt Bike Q & A
https://vintagedirtbikeforums.alp-sys.com/

MT250 Front Turn Signals
https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=2179		 Page 1 of 1
Author:  snhuklm [ Thu Feb 26, 2009 12:10 pm ]
Post subject:  MT250 Front Turn Signals
Hi Everyone,

After the oil pump fiasco, I am on to new ventures. I'm starting to trace the wiring harness and am having some trouble with the front directionals.

There is one wire coming out of the front directionals, but there obviously should be two as the wiring diargram states. How do the front turn signals get wired properly?

Also, the lightbulb next to the winker relay in the wiring diagram - what is this for? I identified the wire, but I'm not sure where it goes or what it's for?

Thanks a lot!!!

Kyle

Attachments:
MT250 Wiring Diagram.jpg
MT250 Wiring Diagram.jpg [ 68.11 KiB | Viewed 4055 times ]
Author:  woosh [ Sun Mar 01, 2009 12:48 pm ]
Post subject:  Re: MT250 Front Turn Signals
Hmm tahts really odd. I am using front signals from a 76 xl250 that I thought were the same and they are grounded to the headlight bracket and only use one wire for power no ground wire.
Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/