Vintage Dirt Bike Q & A

Anything and everything about Vintage Dirt Bikes! After you Register, email nathan@alp-sys.com and let me know so I can activate you.
It is currently Fri Jun 20, 2025 11:36 am

View unanswered posts | View active topics


Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
bentmetal1
PostPosted: Mon May 25, 2009 1:02 pm 
Offline

Joined: Sun May 24, 2009 7:43 pm
Posts: 5
im trying to get a picture of the intake side of the cylinder but i cant find 1 on the internet. im trying to find out if there should be reed valves there or not. there currently is nothing there.... trying to verify
Top
 Profile  
 
rayivers
PostPosted: Mon May 25, 2009 1:53 pm 
Offline

Joined: Sun Nov 30, 2008 12:10 pm
Posts: 1010
Location: Connecticut, USA
Here's a picture of the MT250 intake manifold - the flange end goes to the cylinder, and the rubber end goes to the carb - no reed valves. Since your MT has no oil injection, make sure the oil line hole near the flange has been sealed up (obviously).

Ray

Attachment:
MT250 Intake Manifold (small).jpg
MT250 Intake Manifold (small).jpg [ 40.94 KiB | Viewed 3311 times ]

_________________
'74 CR125M (175cc), '75 MR175, '82 RM250Z, '08 YZ250F, '14 Zero FX electric, '14 Zero MX electric, '18 Alta MXR electric
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]

Who is online

Users browsing this forum: Google [Bot] and 20 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group