Vintage Dirt Bike Q & A
https://vintagedirtbikeforums.alp-sys.com/

1979 CR125 Fork Oil
https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=244		 Page 1 of 1
Author:  Pat [ Sun May 09, 2004 11:56 pm ]
Post subject:  1979 CR125 Fork Oil
Greetings,

Another fork oil question! I have searched the archives, but can't find anything about how much oil to put in the forks of a 79 CR125 on a complete rebuild. The clymer manual only specifies for re-filling, and for a rebuild it says that factory data isn't available.

I had asked some questions a few weeks back about my bike... it's back from powder coat and I got a shade that's VERY close to original.. new fenders, rebuilt engine, new cables etc... I did a nice rebuild that looks good, but is made to RIDE, as opposed sitting in my garage looking pretty. Thanks everyone for not letting me go overboard and do a complete restoration :)

-Pat-
Author:  Nathan [ Mon May 10, 2004 9:13 am ]
Post subject: 
Pat,

If you can't find the figures for a complete overhaul, you can always put a small amount in the forks and bounce up and down on them. Then drain all the oil and then use the refill figures.
Author:  Pat [ Mon May 10, 2004 10:44 am ]
Post subject: 
I should have thought of that.....!

Thanks,
-Pat-
Author:  redrocket190 [ Mon May 10, 2004 2:17 pm ]
Post subject: 
The volumes for the 1979 CR250R 39mm stock forks are 205cc and 275cc respectively or a ratio of 1.34. You could apply that ratio to your refill figure as a guestimate. If you have a tool to set fork oil level you could then adjust the height to suit once the forks are back on the bike.
Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/