| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| CR125M Pipe https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=2593 |
Page 1 of 1 |
| Author: | Scrappy [ Tue Feb 09, 2010 10:56 am ] | ||
| Post subject: | CR125M Pipe | ||
Hi, I picked up a 1974 CR125M some time ago and this pipe (see photo) was on it. Does anyone know what make this pipe is? sort of looks like an FMF but I don't know. Thanks for the help.
|
|||
| Author: | rayivers [ Thu Feb 11, 2010 9:07 pm ] |
| Post subject: | Re: CR125M Pipe |
It's possible this is an early Jemco pipe, as the welding and cones look very similar to both my Jemcos. I don't know if Jemcos ever had snap-ring silencer retainers like this pipe has, though. I don't believe it's a DG or LOP pipe, as both of these had a small rounded 'step-down' piece where the center section meets the rear cone - I think the FMF pipe may have had it too. Is the spring retainer a loop of small-diameter rod, or a hook bracket? Ray |
|
| Author: | Scrappy [ Thu Feb 11, 2010 9:30 pm ] |
| Post subject: | Re: CR125M Pipe |
Hi Ray, Thanks for the reply. The spring retainer is a bracket about 5/8" thick. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|