| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| 79 cr250 bearing https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=2904 |
Page 1 of 1 |
| Author: | crcraig [ Wed Dec 15, 2010 7:40 pm ] |
| Post subject: | 79 cr250 bearing |
anyone know how to remove the clutch lifter shaft bearing on 79 cr250 I need to remove for blasting and powder coat thanks, Craig |
|
| Author: | b-joe [ Thu Dec 16, 2010 10:01 am ] |
| Post subject: | Re: 79 cr250 bearing |
i tig-weld an allenscrew whitch head fits into the bearing to it. than heat the case and pull at the screw. or your next motorcycle shop may help you, they have special tools for pulling sutch bearings. |
|
| Author: | crcraig [ Fri Dec 17, 2010 6:03 am ] |
| Post subject: | Re: 79 cr250 bearing |
I guess I will bring it to my local shop to be pulled the bearing is NA is there another source to get one |
|
| Author: | b-joe [ Fri Dec 17, 2010 12:11 pm ] |
| Post subject: | Re: 79 cr250 bearing |
it´s a standart bearing, HK1612 id 16mm od 22mm h 12mm the small seal is also std. 16x22x3mm |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|