| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| WANTED: '73-'74 CR250 Cylinder, Head & Intake https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=2953 |
Page 1 of 1 |
| Author: | ~JM~ [ Fri Feb 18, 2011 1:18 pm ] |
| Post subject: | WANTED: '73-'74 CR250 Cylinder, Head & Intake |
Looking to buy a '73-'74 CR250 Cylinder, Head & Intake Manifold. Head & Cylinder need to be in good condition. Prefer original bore or "1 over". All cooling fins intact, etc. Please send me a PM, e-mail, or even reply here if you'd prefer. Thanks ~JM~ |
|
| Author: | Nathan [ Mon Feb 21, 2011 3:10 pm ] |
| Post subject: | Re: WANTED: '73-'74 CR250 Cylinder, Head & Intake |
Your best bet is to post and ad on the Elsinore Swap Meet. http://elsinore-swap-meet.com |
|
| Author: | ~JM~ [ Mon Feb 21, 2011 3:35 pm ] |
| Post subject: | Re: WANTED: '73-'74 CR250 Cylinder, Head & Intake |
Thanks for the link, I'll give it a shot. |
|
| Author: | Danny955i [ Sat Feb 26, 2011 12:48 am ] |
| Post subject: | Re: WANTED: '73-'74 CR250 Cylinder, Head & Intake |
There are a few on e-bay I've seen recently. Are these going on a CR or are you doing a MT/CR or MR/CR swap? |
|
| Author: | ~JM~ [ Mon Feb 28, 2011 12:51 pm ] |
| Post subject: | Re: WANTED: '73-'74 CR250 Cylinder, Head & Intake |
I have an MT that I want to swap the CR top-end onto. |
|
| Author: | Danny955i [ Mon Feb 28, 2011 8:19 pm ] |
| Post subject: | Re: WANTED: '73-'74 CR250 Cylinder, Head & Intake |
I was thinking that... I'm planning the same thing... hence the e-bay trolling... Check it out though, you can normally find a cylinder and a head for about 200 bucks in decent shape. Then, just go to DennisKirk.com and buy a new piston for the CR. 300 bucks worth of new performance top-end. Not bad. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|