The lg center bolt on the puller that screws into the center of the flywheel has a metric thread size of 18 (probably a 2.50 pitch). See attached pic.
| Attachments: |
|
MT125 Flywheel Puller 1974.JPG [ 47.43 KiB | Viewed 6784 times ] |
| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| '74 mt125 flywheel puller https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=3799 |
Page 1 of 1 |
| Author: | lusername [ Wed Sep 19, 2012 9:25 am ] |
| Post subject: | '74 mt125 flywheel puller |
anybody know what size threads are on the flywheel on a '74 mt125? I'm looking for a puller. honda part #07933-3950000 does not work |
|
| Author: | jammin [ Fri Sep 21, 2012 5:03 pm ] |
| Post subject: | Re: '74 mt125 flywheel puller |
Correct p# is 07937-4300000 as shown on puller I bought from Honda some time around '82. I'll see if I can determine the thread size and get back to you. |
|
| Author: | jammin [ Sat Sep 22, 2012 1:33 pm ] | ||
| Post subject: | Re: '74 mt125 flywheel puller | ||
The lg center bolt on the puller that screws into the center of the flywheel has a metric thread size of 18 (probably a 2.50 pitch). See attached pic.
|
|||
| Author: | lusername [ Tue Sep 25, 2012 7:30 pm ] |
| Post subject: | Re: '74 mt125 flywheel puller |
I have a 20mm puller that's not near big enough |
|
| Author: | jammin [ Wed Sep 26, 2012 7:23 am ] |
| Post subject: | Re: '74 mt125 flywheel puller |
The tool in the pic I posted pulled the flywheel off my '74 MT125 a couple years ago. I wonder if Honda changed thread sizes during production. Strange. |
|
| Author: | rayivers [ Wed Sep 26, 2012 8:48 am ] |
| Post subject: | Re: '74 mt125 flywheel puller |
Just a guess, but the MT125 flywheel threads look the same as on the MR175 flywheel. This flywheel takes an M27x1.0 LH-thread male internal-thread puller, such as the K&N 82-0150, Motion Pro 08-0026, etc. Ray |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|