| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| mr175 crankshaft kit https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=4137 |
Page 1 of 1 |
| Author: | mbilder [ Wed Aug 21, 2013 7:44 am ] |
| Post subject: | mr175 crankshaft kit |
I have two MR175 crankshafts with too much slop in them. I have been looking for the bearing, pin, etc. but can't find any. Anyone know where to find a rebuild kit, or if another cranshaft's pin, etc will work? |
|
| Author: | rayivers [ Wed Aug 21, 2013 1:13 pm ] |
| Post subject: | Re: mr175 crankshaft kit |
MR175 crank rebuilds are kind of a nightmare, as the rods are practically nonexistant (if the rod feels sloppy surely its big end surface is at least partially to blame, although a new bearing and crankpin might improve things a lot). My friend is presently working with Crank Works to see if it's possible to hone the rod end for an oversize bearing and/or pin, or use an early RD350 rod, which I believe is 1mm longer ctr-ctr but otherwise very similar. It's actually easier to find a NOS MR175 crank than a rod. Here are the bearing substitutions I have; the KA3 and KS3 parts are for the '81-'83 CR125R. Some are still available OEM: 91004-373-006 / 91004-373-300 / 91004-KA3-003 / 91004-KA3-004 / 91004-KS3-901 91005-373-006 / 91005-KA3-003 / 91005-KA3-004 / 91005-KS3-901 91006-373-006 / 91006-373-300 / 91006-KA3-003 / 91006-KA3-004 I've managed to find all three crankpins, using eBay and Google. 13381-373-300 / 13381-373-310 (2 groove) 13382-373-300 (1 groove) 13383-373-300 (no groove) Ray |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|