Hi folks,
does anyone have one of these or know where I could get one or any info as to this item or other reed valves?
cheers people
| Attachments: |
|
Reed Valve.JPG [ 5.26 KiB | Viewed 6258 times ] |
| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| Reed Valve https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=4216 |
Page 1 of 1 |
| Author: | bollockybill [ Wed Jan 01, 2014 8:25 am ] | ||
| Post subject: | Reed Valve | ||
Hi folks, does anyone have one of these or know where I could get one or any info as to this item or other reed valves? cheers people
|
|||
| Author: | rayivers [ Wed Jan 01, 2014 11:31 am ] |
| Post subject: | Re: Reed Valve |
That looks like a G.E.M. reed valve to me, but I could be wrong. They pop up on eBay from time to time. The setup below is way better, and probably way more $$. http://richstaylordporting.com/intake.html Ray |
|
| Author: | bollockybill [ Thu Jan 02, 2014 8:58 am ] | ||
| Post subject: | Re: Reed Valve | ||
Is this one?
|
|||
| Author: | rayivers [ Thu Jan 02, 2014 9:32 am ] |
| Post subject: | Re: Reed Valve |
That looks like a DH reed kit. If you're installing from scratch, I'm sure you're aware there's a lot of work involved to correctly install this kit (intake passage mods, adding piston-skirt windows, boost port cut, etc.). If you're going to go to all that trouble anyway I'd suggest using a modern reed assembly instead, but that's just my opinion. On page 2 of the .pdf link below is a DH installation diagram for the Hodaka 125, which gives a general idea of what's required. http://www.strictlyhodaka.com/v/vspfiles/assets/RV.pdf Ray |
|
| Author: | ohiomotoxer [ Thu Jan 09, 2014 12:04 pm ] |
| Post subject: | Re: Reed Valve |
Top oneis a GEM (that pic is of my old one actually) the bottom is a DH. Don't forget you WILL need to put some holes in the piston for any reed to work. I have the diagram for a 123 somewhere if you need I will look for it. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|