| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| MT250 Flywheel puller https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=4703 |
Page 1 of 1 |
| Author: | MT250GUY [ Sat Nov 12, 2016 5:55 am ] |
| Post subject: | MT250 Flywheel puller |
I assume any puller for this bike is going to consist of two pieces. One hollow 20 mm threaded collar and a bolt that threads into the collar to torque on to "pop" the flywheel off. It appears a BikeMaster - 150604/MP7 is correct, but every depiction of the tool only shows the collar and not a bolt that threads on it. Confused noob! |
|
| Author: | rayivers [ Sat Nov 12, 2016 7:19 am ] |
| Post subject: | Re: MT250 Flywheel puller |
The Honda MT250 07933-3580000 flywheel puller (shown on page 92 of the shop manual) has been superceded by the 07933-3950000 MR250 puller in the link below. It's a T-handle outer-threaded tube which pushes against the end of the crank (no bolt). http://www.ebay.com/itm/Honda-07933-395 ... rZ&vxp=mtr Here's another one, without the T-handle (which should allow much more torque to be applied): http://www.ebay.com/itm/20mm-PULLER-TOO ... 09&vxp=mtr Ray |
|
| Author: | MT250GUY [ Sun Nov 13, 2016 9:23 am ] |
| Post subject: | Re: MT250 Flywheel puller |
Thanks Ray. Ordered it. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|