| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| Looking to validate bearing #s https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=4738 |
Page 1 of 1 |
| Author: | jsjamboree [ Tue Feb 14, 2017 9:52 am ] |
| Post subject: | Looking to validate bearing #s |
Hey guys, new to the forum, building up an MT250. Need to replace the the right small countershaft bearings and the left crank bearing. Looking on CMSNL im not confident I have the right part numbers. Hoping someone can make sure im on point before i spend the money. Left Crank Bearing
Thanks! Pic |
|
| Author: | rayivers [ Tue Feb 14, 2017 7:03 pm ] |
| Post subject: | Re: Looking to validate bearing #s |
Your part numbers are correct for the MT250 96102- LH and RH crankshaft bearings and the 91005- RH countershaft bearing. Ray |
|
| Author: | Rustynutz [ Tue Feb 14, 2017 7:07 pm ] |
| Post subject: | Re: Looking to validate bearing #s |
check out boss bearings, same as CR250 |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|