| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| '74 cr250 https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=536 |
Page 1 of 1 |
| Author: | 74elsieguy [ Tue Feb 01, 2005 6:24 pm ] |
| Post subject: | '74 cr250 |
ok,a little help here.the bore on my cylinder is 2.776 inches(half out of round).Is the 1rst over? when i measured the ring gap i had .030 which said out of speck acording to the manuel. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|