Vintage Dirt Bike Q & A

Anything and everything about Vintage Dirt Bikes! After you Register, email nathan@alp-sys.com and let me know so I can activate you.
It is currently Sat Jul 05, 2025 6:38 am

View unanswered posts | View active topics


Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
slowpro48
 Post subject: MR175 jetting
PostPosted: Wed Jun 29, 2005 9:42 pm 
Offline

Joined: Wed Jun 29, 2005 2:53 pm
Posts: 3
Can someone tell me the following stock specs for the MR175?

main jet
pilot jet
needle
needle position
float height

also does this carb have an air screw or fuel screw - i.e., is clockwise richer or leaner?

thanks
Top
 Profile  
 
slowpro48
 Post subject:
PostPosted: Fri Jul 08, 2005 12:34 pm 
Offline

Joined: Wed Jun 29, 2005 2:53 pm
Posts: 3
Well so much for the "Get quick answers to your questions about Honda CR's, MR's & MT's from fellow Honda enthusiasts here." :? Guess I'll just have to answer my own question! Found on smokeriders.com:

main = 122
pilot = 48
needle position = 5th from top (i.e., the bottom groove - kinda unusual)
float level = 20mm
pilot air screw = 1.25 turns out (+ or - 0.25)

hope these baseline specs help someone in the future...
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 44 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group