Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
1988 cr-250 cylinder https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=855 |
Page 1 of 1 |
Author: | ridevintagered [ Sat Dec 24, 2005 3:21 pm ] |
Post subject: | 1988 cr-250 cylinder |
does anyone have a good cylinder they would part with? i know i can send this one out to be replated, but thought i might find a decent one cheaper. is there any way to bore these and use another piston-ring setup? |
Author: | tomh. [ Wed Jan 04, 2006 8:55 am ] |
Post subject: | |
You can have a sleeve (at LA Sleeve among others) installed so it can be bored. But because of the exhaust valve, I'd have it plated. I've had excellent service from US Chrome of Wisconsin 866-922-5066 |
Author: | ridevintagered [ Wed Jan 04, 2006 11:37 am ] |
Post subject: | |
thanx,mike |
Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |