Vintage Dirt Bike Q & A
https://vintagedirtbikeforums.alp-sys.com/

carb rebuild
https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=878
Page 1 of 1

Author:  candt [ Sun Jan 15, 2006 9:58 pm ]
Post subject:  carb rebuild

Hello......while going through the carb on my 75 mt250, a very small piece that looks like a brass bushing fell out, and I have no idea where it fell from. Does anybody have a clue where this goes?

Author:  Rick [ Sun Jan 15, 2006 11:11 pm ]
Post subject: 

Washer or bushing?
If it is a washer it is probably from under the spring for the idle.
If it more like a barrell it may be where the needle valve slides into/through. I never had one of those fall out. I am recalling both above comments to years ago and 4-strokes. Might be the same.
Can you post a pic of it?

Author:  candt [ Tue Jan 17, 2006 10:59 am ]
Post subject: 

It is shaped like a barrel, and I had suspected that it goes where the needle valve slides into. Thanks for the help.

Author:  redrocket190 [ Wed Jan 18, 2006 3:18 pm ]
Post subject: 

Check out http://www.sudco.com for some exploded parts diagrams...

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/