Thanks
I'll start saving up...
| Vintage Dirt Bike Q & A https://vintagedirtbikeforums.alp-sys.com/ |
|
| 74 CR250 Elsinore and the PVL ignition https://vintagedirtbikeforums.alp-sys.com/viewtopic.php?f=21&t=981 |
Page 1 of 1 |
| Author: | Domenic [ Wed Apr 05, 2006 9:35 am ] |
| Post subject: | 74 CR250 Elsinore and the PVL ignition |
I searched and read what I could find...Seriously considering ordering one for my bike. Does this ignition require machining of side cover or flywheel? Anything else I need to know? Thanks |
|
| Author: | Nathan [ Wed Apr 05, 2006 11:46 am ] |
| Post subject: | |
No machining. Pretty easy install. I installed one on my 73 CR250M and it works great. No more points problems! I don't even think about the ignition anymore, much less worry about it. If you have the $$$ (they ain't cheap) go for it. |
|
| Author: | FirePig [ Wed Apr 05, 2006 3:49 pm ] |
| Post subject: | |
I've run one for about four years now and it works great. Highly recommended if you have the bucks. |
|
| Author: | Domenic [ Thu Apr 06, 2006 7:14 am ] |
| Post subject: | |
Thanks I'll start saving up...
|
|
| Author: | Domenic [ Sun May 21, 2006 3:33 pm ] |
| Post subject: | |
Well after destroying two pairs of boots and one ankle from kickback,  the PVL ignition is finally installed!! Set the timing at .070” btdc..Seems to have a lot more power and runs very smooth. Would highly recommend the switch from points and advanced timing. Also saves on kick start pawls and ankles. 
|
|
| Author: | mitchie [ Tue May 23, 2006 6:48 am ] |
| Post subject: | |
How much are these units??? |
|
| Author: | Domenic [ Wed May 24, 2006 8:32 am ] |
| Post subject: | |
$375 from http://www.pro-flo.com |
|
| Author: | frohrs [ Tue Jun 13, 2006 5:23 pm ] |
| Post subject: | PVL Ignition 1974 CR250 Honda |
Does the Instructions for the PVL Ignition tell you what to set the timing at? I would think so. I know it's mentioned here at .070 at btdc. Thanks Forrest Rohrs 1982 CR250R 1980 CR125R 1974 CR250M |
|
| Author: | Nathan [ Tue Jun 13, 2006 6:58 pm ] |
| Post subject: | |
|
|
| Author: | frohrs [ Tue Jun 13, 2006 8:39 pm ] |
| Post subject: | 74 CR250 PVL |
There we go! Thank you Sir! Forrest Rohrs |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|