Vintage Dirt Bike Q & A

Anything and everything about Vintage Dirt Bikes! After you Register, email nathan@alp-sys.com and let me know so I can activate you.
It is currently Thu Jun 19, 2025 3:47 pm

View unanswered posts | View active topics


Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
crcraig
 Post subject: o-ring size
PostPosted: Fri Sep 30, 2011 5:58 pm 
Offline

Joined: Fri Oct 01, 2010 5:50 pm
Posts: 63
anybody know the diameter of the o-rings that hold on the front # plate 79 cr250 I just got original plate but need o-rings I had an after market plate on front but do not like the mounting of it
Top
 Profile  
 
redrocket190
 Post subject: Re: o-ring size
PostPosted: Wed Oct 05, 2011 9:47 am 
Offline

Joined: Fri Feb 27, 2004 10:20 pm
Posts: 906
Location: San Clemente, CA
Find an appliance repair shop and check out their supply of sewing machine drive belts and/or vacuum cleaner belts. I personally found the latter to thick / strong and they deformed the mounting tabs. The former work OK but have a shorter lifespan. BTW, you can use the same source for the rubber band that pinches the side panels to the air box.

_________________
Michael Stiles
1979 Honda CR250R Elsinore | 2006 Husqvarna SM510R | 2007 Service Honda CR500R-AF
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 44 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group