Vintage Dirt Bike Q & A

Anything and everything about Vintage Dirt Bikes! After you Register, email nathan@alp-sys.com and let me know so I can activate you.
It is currently Sat Jul 05, 2025 9:46 pm

View unanswered posts | View active topics


Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Print view Previous topic | Next topic 
Author Message
ridevintagered
 Post subject: 1988 cr-250 cylinder
PostPosted: Sat Dec 24, 2005 3:21 pm 
Offline

Joined: Sat May 14, 2005 7:20 am
Posts: 2
does anyone have a good cylinder they would part with? i know i can send this one out to be replated, but thought i might find a decent one cheaper. is there any way to bore these and use another piston-ring setup?
Top
 Profile  
 
tomh.
 Post subject:
PostPosted: Wed Jan 04, 2006 8:55 am 
Offline
User avatar

Joined: Sun Apr 04, 2004 11:46 am
Posts: 39
Location: N.W. Ohio
You can have a sleeve (at LA Sleeve among others) installed so it can be bored. But because of the exhaust valve, I'd have it plated. I've had excellent service from US Chrome of Wisconsin 866-922-5066
Top
 Profile  
 
ridevintagered
 Post subject:
PostPosted: Wed Jan 04, 2006 11:37 am 
Offline

Joined: Sat May 14, 2005 7:20 am
Posts: 2
thanx,mike
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 48 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group