Vintage Dirt Bike Q & A • View topic - elsinore rear wheel question

View unanswered posts | View active topics

Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]

elsinore rear wheel question

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

cleopatrisha

Post subject: elsinore rear wheel question

Posted: Tue Sep 12, 2006 12:23 pm

Joined: Thu Aug 03, 2006 9:55 am
Posts: 13

Everything is tight and I can still grab a hold of my rear wheel and slightly wiggle it back and forth does this mean I need new bearings or am I missing a flat washer on the axle bolt the axle bolt inside the swingarm? the bearings dont sqeal or make any noise.

Top

Go4Ducks2

Post subject:

Posted: Tue Sep 12, 2006 6:27 pm

Joined: Fri Jun 02, 2006 9:06 pm
Posts: 109
Location: St. Louis, Mo

Do the bearings have any slop in them? Only washer I can think of is the one over the brake housing...the one with the rubber o-ring behind it.
Spacer on each side of the rear wheel and thats it.
I'd take a close look at the bearings, they should be tight, no play in the inner race that the axle rides on. And I'd double check and make sure the play isn't coming from the swingarm pivot, bad bearings and bushings there. Food for thought.

_________________
Garry Mainer
#33m (retired)
Honda Cr250r 1980
Honda Cr250r 1980
Yamaha TY250C 1976
Arctic Cat 650 H1 2007

Top

Page 1 of 1

[ 2 posts ]

Board index » Questions & Answers » Honda CR, MR & MT

All times are UTC - 7 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 32 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum